Rj-45 Management Port; Reset Button - Lenovo RackSwitch G8264 Installation Manual

RJ-45 Management Port

RJ-45 Management LEDs

Reset Button

© Copyright Lenovo 2017
The RJ‐45 management port on the front panel supports 10/100/1000BASE‐T, in‐line
switch management.
To attach an RJ‐45 connector to the switch, push the RJ‐45 cable connector into the
port connector until it clicks into place.
To disconnect the RJ‐45 cable, squeeze the release tab and gently pull the cable
connector out of the switch connector.
The RJ‐45 management port LEDs are oriented as shown in the following figure.
Figure 5. RJ‐45 management port LEDs
Link LED
Status LEDs for the RJ‐45 management port are described in the following table.
Table 3.
RJ-45 status LEDs behavior
LED State
Link Steady green
Off
Activity Flashing amber Activity
Off
The Reset button is recessed within a hole on the front panel. Use a straightened
paper clip or similar object to press the Reset button. The Reset button allows
technicians to reset the switch as follows:
 Normal reset—Press and release Reset. The switch resets and reloads the
configuration files.
Factory reset—Press and hold Reset for more than five seconds. The switch

resets and reverts all configuration settings to the factory defaults.
Activity LED
Functional Meaning
Link up
No link
No activity
Chapter 2: Switch Components
21