RJ45 Management Port
The RJ45 management port on the front panel supports 10/100/1000BASE‐T, in‐line
switch management.
To attach an RJ45 connector to the switch, push the RJ45 cable connector into the
port connector until it clicks into place.
To disconnect the RJ45 cable, squeeze the release tab and gently pull the cable
connector out of the switch connector.
RJ45 Management LEDs
The RJ45 management port LEDs are oriented as shown in the following figure.
Figure 5. RJ45 management port LEDs
Status LEDs for the RJ45 management port are described in the following table.
Table 2.
LED
Link
Speed
Reset Button
The Reset button is recessed within a hole on the front panel. Use a straightened
paper clip or similar object to press the Reset button. The Reset button allows
technicians to reset the switch as follows:
20
NE2572O Installation Guide
All manuals and user guides at all-guides.com
Link LED
RJ45 status LEDs behavior
State
Flashing green
Steady green
Off
Steady green
Off
Normal reset—press and release reset button. The switch will start a forced
reload procedure without saving the current configuration. This action is
intended for when the switch is unresponsive and needs to be restarted to
resume its normal functions.
Speed LED
Functional Meaning
Activity
Link up
No link
100/1000 Mbps connection
10 Mbps connection or no link