Oki - Standard Model - Oki POS 425D Developer's Manual

2.3.2 OKI — Standard Model
No.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
O = default value
Note 1) I/F control information (baud rate, etc.) and customer display connection/disconnection of serial model are set by
DIP-SW on the I/F board.
Note 2) MICR Unit selection has the following two types for MICR Read test (Refer to Section 2.6): "Yes (CMC-7)," and
"Yes (E-13B)." Normally, either selection is recognized as an actual installation status of MICR Unit, and MICR type is
selected by designation of the command.
Note 3) For No. 3, 4, and 5, adjust to the proper values at factory shipment.
|
OKIPOS 425D
38
Item
Auto Cutter Unit Selects Auto Cutter Unit Installed/Not
Installed
MICR Unit Selects MICR Unit Installed/Not Installed
Print Registration Adjusts the print position if it shifts in
Forward printing and Reverse printing
Top Adjust Adjusts Top Of Form position when
Slip/Sprocket are used.
Cut Adjust Adjusts Cut Position when cutting
sprocket paper.
Auto LF Selects auto line feed.
(Auto line feed) (Selects auto line feed by CR Code)
Receive Buffer Size Selects Receive Buffer Size
Print Mode Selects font
Off-line Busy Selects conditions of BUSY
Control
Cover Open Alarm Selects enable/disable of print stop in
Cover Open
Width of Roll Paper Selects the paper width of Roll paper
(Changes the print area)
Zero Character Selects a zero font
Page Length Selects the paper length of Sprocket paper
Paper End Signal Selects the paper sensor that enables Paper
End Signal.
RNE: Receipt/Journal Near End
Sensor
RE: Receipt/Journal End Sensor
A25007.doc
Function
O Yes
No
Yes(CMC-7)
Yes(E-13B)
O No
0.25mm Right
0.20mm Right
0.15mm Right
0.10mm Right
0.05mm Right
0
0.05mm Left
0.10mm Left
0.15mm Left
0.20mm Left
0.25mm Left
-1.75mm ~ +1.75mm
*Can be set in the 0.35mm
unit
*Default value: 0 mm
-1.75mm ~ +1.75mm
*Can be set in the 0.35mm
unit
*Default value: 0 mm
Yes
O No
2K
O 16K
O Utility
HSD
O Yes (Off-line or receive
buffer-full)
No (Receive buffer-full)
O Yes
No
O 76.2mm
69.5mm
Slashed
O Unslashed
88.9mm
139.7mm
215.9mm
O 279.4mm
304.8mm
O Yes (RNE or RE)
Yes (RE)
No
Sets