Oki POS 425D Developer's Manual page 52

4. Remove the paper roll (Journal) on the rewinder following the procedure below.
(1) Remove the rewinder (1) from the printer.
(2) Rotate the flange (2) in the direction shown below and remove it from the rewinder.
Note 1: Rotation direction of the flange varies depending on the width of the Roll Paper.
Arrow 3:
Arrow 4:
Note 2: When a spacer is installed, remove the spacer along with the flange.
o425_73.jpg
2
3
4
(3) Pull the Roll Paper (1) out from the rewinder (2). When it is tight, rotate the rewinder in the direction below, and pull
out the paper.
o425_74.jpg
1
5. Load new paper roll.
For loading Roll Paper, refer to Section 1.5.1.4.
|
OKIPOS 425D
52
Wide Roll Paper (Width: 76.2 mm)
Narrow Roll Paper (Width: 69.5 mm)
2
1