Oki POS 425D Developer's Manual page 74

2 Counterfoil and Stub
OP425_11.eps
1
1 Printing area
2 Stub
3 Inserting direction
A25023.doc
Symbol Designation
W Paper width
L Paper length
A Print starting position
B Left margin
C Right margin
D Printing area width
Note 1 To feed paper, insert a paper from the top side of the device and keep holding it until printing ends.
Note 2 Use a flat sheet free curls, bends (especially those on its edges), cambers, wrinkles, etc. If a sheet is not flat, it may
be contaminated with ink due to ink ribbon contact.
Note 3 Before printing on a stub, fold the other sheets backward to make the stub available for print as shown in the fig.
below.
OP425_12.eps
1
1 Fold backward
2 Stub
|
OKIPOS 425D
74
Standard Value
70mm (2.76 inch) or more
40mm (1.57 inch) or more
18mm (0.7 inch) or less
2.54mm (0.1 inch) or more
2.54mm (0.1 inch)
Max 160.02mm (6.3 inch)
2
3
2