Table of Contents
Advertisement
USB
MENU
This menu controls the operation of the printer's USB data interface.
ITEM
SOFT RESET
SPEED
SERIAL NUMBER
NOTE:
When you have changed any settings in the USB MENU, turn the printer OFF,
then ON again.
N
ETWORK MENU
This menu controls the operation of the printer's 10Base-T/100Base-TX network interface.
ITEM
TCP/IP
NETBEUI
IP ADDRESS SET
IP ADDRESS
SUBNET MASK
GATEWAY ADDRESS
WEB
TELNET
FTP
SNMP
NETWORK SCALE
HUB LINK SETTING
SETTINGS
EXPLANATION
ENABLE /
Enables or disables the SOFT RESET command.
DISABLE
12 / 480 Mps
Selects the interface speed.
ENABLE / DISABLE
Specifies whether to ENABLE or DISABLE a USB serial
number.
The USB serial number is used to identify the USB device
connected to your PC.
SETTINGS
EXPLANATION
ENABLE /
Enables or disables this network protocol.
DISABLE
ENABLE /
Enables or disables this network protocol.
DISABLE
AUTO / MANUAL
Specifies whether IP address allocation is automatic
(DHCP) or manually assigned.
xxx.xxx.xxx.xxx
Current assigned IP address. To change, press ENTER and
use up or down buttons to increment 1st octet, then press
ENTER again to move on to next octet. When 4th octet
has been set, press ENTER again to register new address.
xxx.xxx.xxx.xxx
Current assigned subnet mask. To change, proceed as
above.
xxx.xxx.xxx.xxx
Current assigned gateway address. To change, proceed as
above.
ENABLE /
Enables or disables Web config. facility.
DISABLE
ENABLE /
Enables or disables Telnet config. facility.
DISABLE
ENABLE /
Enables or disables communication via FTP.
DISABLE
ENABLE /
Enables or disables SNMP protocol.
DISABLE
NORMAL / SMALL
Selects network size.
AUTO
Sets full or half duplex for communication via a network
NEGOTIATE
hub.
100BASE-TX FULL
100BASE-TX HALF
10BASE-T FULL
10BASE-T HALF
Menu functions - C801 and C810 > 43
Advertisement
Table of Contents
