Usb Menu; Network Menu - Oki ES5430 User Manual

USB
MENU
This menu controls the operation of the printer's USB data interface.
ITEM
SOFT RESET
SPEED
OFFLINE RECEIVE
SERIAL NUMBER
NOTE
When you have changed any settings in the USB MENU, turn the printer OFF,
then ON again.
N
ETWORK MENU
This menu controls the operation of the printer's 10Base-T/100Base-TX network interface.
ITEM
TCP/IP
IP VERSION
NETBEUI
NETBIOS OVER TCP
NETWARE
ETHERTALK
FRAME TYPE
IP ADDRESS SET
IPV4 ADDRESS
SETTINGS
ENABLE / DISABLE
12Mbps / 480Mbps
ENABLE / DISABLE
ENABLE / DISABLE
SETTINGS
ENABLE / DISABLE
IP v4
IP v4+v6
IP v6
ENABLE / DISABLE
ENABLE / DISABLE
ENABLE / DISABLE
ENABLE / DISABLE
AUTO / 802.2 / 802.3 /
ETHERNET II / SNAP
AUTO / MANUAL
xxx.xxx.xxx.xxx
Menu functions > 34
EXPLANATION
Enables or disables the SOFT RESET command.
Selects the interface speed.
Enables or disables this function. When set to Enable,
the interface retains a receive possible state even when
switching to Offline. Interface sends the BUSY signal
only when the receive buffer is full or a service call
occurs.
Specifies whether to ENABLE or DISABLE a USB serial
number.
The USB serial number is used to identify the USB
device connected to your PC.
EXPLANATION
Enables or disables this network protocol.
Sets up the IP version.
Operates with IPv4 only (not valid with IPv6).
Operates with both IPv4 and IPv6.
Operates with IPv6 only (not valid with IPv4).
From this stage, if IPv6 only is set from UI, for example
Telnet, "IP v6" appears as the value of IP Version on
the operation panel. "IP v6" will disappear from the
value if "IP v4" or "IP v4+v6" is selected.
Display Condition: TCP/IP should be enabled.
Enables or disables this network protocol.
Sets Enable/Disable of NetBIOS over TCP protocol.
Display Conditions:
> > TCP/IP should be enabled.
> > IP Version is not IPv6.
Enables or disables this network protocol.
Enables or disables this network protocol.
Selects the Ethernet MAC layer frame type.
Display Condition: Netware should be enabled.
Specifies whether IP address allocation is automatic
(DHCP) or manually assigned.
Current assigned IP address. To change, press OK and
use Menu buttons to increment 1st octet, then press
OK again to move on to next octet. When 4th octet has
been set, press OK again to register new address.