Table of Contents
Advertisement
To synchronize mirrored drives manually
The most efficient method to synchronize Virtual
Tape configurations is to enable Hot Spares or the
auto rebuild feature.
1
Connect to Diamond Storage Array services via
the RS-232 port or the optional Ethernet
management services card (see
Diamond-VT
on page 15). You should now be in
CLI.
2
Access the RAID page of the ExpressNAV
ATTO ExpressNAV: Browser-based
interface (see
Interface
on page 23).
VirtualDriveInfo and TapeVolumeInfo
3
Use the
commands to identify a Tape Volume associated
with the RAID group you wish to rebuild.
4
5
6
Accessing the
Go to the Move Medium page.
Drag the selected Tape Volume into an
unoccupied Tape Drive LUN.
From the CLI window, initiate a Rebuild operation
from the Tape Drive LUN to the desired Drive
Sled.
Note
When this rebuild operation has completed, the
entire RAID group will have been rebuilt,
effectively rebuilding all Tape Volumes
associated with the underlying RAID Group: you
do not need to rebuild each Tape Volume
separately.
66
rebuilding RAID
Advertisement
Table of Contents
