Table of Contents
Advertisement
Logical Units
Displays information on the logical units which have
been configured and allows you to change the status
from online or offline or degraded.
Partitions
Displays the current configuration of the Diamond-VT
including
• Partition ID
• Virtual Drive ID
• LUN
• Capacity of each partition
See Drive Management Commands on page 41 for more
information.
Zoning
Displays the current configuration of the Diamond-
VT. Changes may be made.
See Zones on page 51 for more information.
Tape Volumes
Displays the Volume ID and capacity, capacity used
and capacity remaining of tape volumes.
You may also Write Protect a Virtual Tape Volume.
See Configuring the Diamond-VT on page 47 for more
information.
Tape Drives
Sets up Virtual Tape configurations and displays the
LUN, state, partition ID, Virtual Disk ID, Tape Volume
ID and the capacity and usage percentage of all the
tape drives.
See Configuring the Diamond-VT on page 47 for more
information.
Move Medium
Manually move the available tape volumes in or out of
a tape drive by dragging and dropping a tape volume
icon onto one of the tape drive icons.
Rebuild
Displays the current status of rebuilds and allows you
to halt, resume or initiate rebuilds.
See Drive Management Commands on page 41 for more
information.
Configuration
Manages with configurable options
• User name
• Password
• Minimum operating temperature
• Maximum operating temperature
• Identify Diamond
• Restore defaults
Refer to Maintenance Services Commands on page 38
for details.
Advanced
Input any CLI command available through the
Diamond-VT while in ExpressNAV
To use the advanced page CLI commands
1
After the page opens and the
appears, type in the CLI command
2
Click the Submit button, the equivalent of typing the
CLI command into a telnet or serial port CLI session.
A text field beneath the box lists the most recent
commands issued to the Diamond-VT.
SaveConfiguration norestart
3
Type
4
Click the Submit button. Your changes are
implemented.
5
To keep the changes through the next power cycle,
FirmwareRestart
type
and click Restart.
Restart
Allows you to implement a firmware restart of the
Diamond-VT. Access is via the
left side of the page.
Note
Restarting the firmware may take a few
minutes.
1
Click the Restart button.
A box asks you to wait until the counter gets to
0 and then the browser refreshes.
2
If the browser does not refresh after the counter gets
to 0, click the link to refresh it manually.
Help
Gives help information about the command line
interface commands and troubleshooting tips. This
page provides links to pages with help text for each
category of options and one link to the
Troubleshooting Tips
website. Contact information for getting in touch with
ATTO technical support is on the right.
When you click a red text box on any page,
ExpressNAV asks for your login information, then
open a dialog box with help text.
Ready
prompt
or go to the Restart page
link on the
Restart
and
page on the ATTO
FAQs
ExpressNAV
26
Advertisement
Table of Contents
