Table of Contents
Advertisement
Zoning is a collection of related Diamond-VT capabilities supporting flexible Diamond configuration
management configurable via CLI commands in the Command Line Interface mode or in the Advanced
CLI Configuration page in the ExpressNAV interface. Zoning supports security by granting or denying
access between initiators and devices as defined by an administrator.
A zone is a collection of devices which can access
each other. The devices in a zone usually include
one or more initiators, one or more devices, and
one or more paths between the initiators and the
devices.
To set up zones, use the Command Line Interface
(see
Accessing the Diamond-VT
Advanced CLI page in the ExpressNAV interface.
Zone CLI commands only take effect after you
enter the ZoneCommit command.
The individual elements are referred to as
device_lun, host_name, port_number and
zone_name as defined in Exhibit 7.3-1.
Exhibit 7.3-1 Definitions of zone configuration entries.
device_lun
The LUN of the RAID drive
host_name
In a Fibre Channel environment, the
WWPN; in a SCSI environment, SCSI
Initiator ID
port_number The Diamond port number (0, 1) for the
data path
zone_name
Alphanumeric or '_', character string less
than or equal to 16 characters long
Principles of Zoning
Zoning provides a validation filter for each SCSI
command.
Each zone entry includes a named zone, a host
portion, a port portion and a device portion. The
components of a valid path from a host to a device
satisfy the following conjunction:
<host_name> AND <port_list> AND
device_list>
is named to identify it from other
The zone
zones. It appears as
zone_name
defines the valid access path
The host portion
from a host through a port to a device (LUN),
representing the Initiator ID in a SCSI
51
ATTO Technology Inc. Diamond Storage Array Installation and Operation Manual
7.3 Zones
on page 15) or the
in this manual.
environment or the World Wide Port Name in a
Fibre Channel environment. It appears as
in this manual.
host_name
defines the LUN(s)
The device portion
participating in the zone. It appears as
in this manual.
defines the Fibre Channel or
The port portion
SCSI port in the Diamond-VT. It appears as
in this manual.
port_n
Each command received by the
The process:
Diamond-VT is parsed to determine its host/HBA
identifier, its port number and the target LUN,
forming the zone nexus. This zone nexus is
looked up in the defined zones table. If the zone
nexus is present, the operation continues; if it is
not found, the command is rejected with the
appropriate status and sense data.
Two zone configurations accessed through the
Command Line Interface regulate zoning:
The Planned configuration
configuration used to build or edit the desired
configuration. The Planned configuration does
not control I/O access until it is transformed into
the Active Zone Configuration via successful
completion of the
ZoneCommit
Other than as a site for zone configuration editing,
the Planned configuration has no impact on the
Active configuration or the Diamond-VT.
Changes to the Planned configuration may be
made without considering synchronization with
other configuration commands.
Use the
ZoneClearAll
Planned configuration.
If, while working in the Planned configuration,
you decide you want to negate that configuration
and edit the Active configuration, use the
command. The information from
ZoneRetrieve
device_lun
is a work-in-process
command.
command to clear the
Advertisement
Table of Contents
