Table of Contents
Advertisement
The Diamond-VT provides a number of indicators to identify the operational status of the array. System status
and error information is readily available. If your situation is not defined here or elsewhere in the manual, if these
solutions do not help, or if you have any questions or concerns about any aspect of operating the Diamond-VT,
contact technical support.
Windows 2000 special instructions
When using Windows 2000 and booting up the
Diamond-VT for the first time, the New Hardware
screen may ask for a driver. While a driver is not
necessary, install a dummy driver to eliminate the
screen's appearance. Download
, unzip it, and install the driver
www.attotech.com
according to the instructions in
Error Messages
If a serious hardware or software
System Fault LED
error occurs in the Diamond-VT, the System Fault
LED will display a series of flashes or blink codes.
• an initial series of blinks indicate a system
problem
Number of blinks
1, 2 or 3
processor or memory
4
Fibre Channel interface
5
SCSI interface
7
Fibre Channel connection
8
general internal processing
9
SCSI Enclosure Services
• a two second pause
• another series of blinks providing more detailed
information for technical personnel.
• a four-second pause
• sequence repetition from step 1 until the error is
cleared.
In general, any fault will require notification of
Diamond Array technical personnel for resolution or
for further debug instructions. When you report an
error code, please provide both the first and second
blink code values.
During a fault condition, more detailed information
about the fault may be available via the CLI or the
ExpressNAV interface over the RS-232 interface port
or the optional Ethernet port. The blink codes are
saved internally by the array to NVRAM and are
displayed at power up.
61
ATTO Technology Inc. Diamond Storage Array Installation and Operation Manual
9.1 Troubleshooting
from
AttoDM2k.zip
.
AttoDM2k.pdf
Problem area
Command Line Interface messages
ERROR. Wrong/Missing Parameters
Check
for the correct input and retype command
Help
ERROR. Invalid Command. Type 'help' for
command list
Check
to find a list of all commands which are
Help
available. Contact Diamond-VT technical support via
the means easiest for you. Refer to Warranty on page
A-xv for additional information.
ERROR. Command Not Processed.
The Diamond-VT did not accept the command you
requested. Check
for a list of commands or check
Help
this manual for the function you wish to access. If you
cannot accomplish what you want to do with the
commands listed, contact Diamond-VT technical
support via the means easiest for you.
The Diamond-VT audible alarm will
Audible Alarm
warn of potential problems or faults. It will beep
repeatedly when the System Fault (FLT) light on the
system management card is activated. The alarm will
turn off when the fault condition is cleared or the alarm
can be disabled by issuing
PowerAudibleAlarm disabled
described in Maintenance Services Commands on page
38. Disabling the alarm for a specific error will not
silence the alarm for other error conditions.
Specific situations and suggestions
For all problems, first check the pages of the
ExpressNAV interface appropriate for the problem
especially the Status and Storage Management or
use the appropriate CLI commands
If a drive fails to respond
• Determine which drive has failed by observing
the amber fault LED on the drive sled or connect
to the CLI and type
drives and their status.
• For specific information on a particular drive in
d r iv ei nfo [ s le d n u mb e r ] [ dr i ve
CLI, type
nu mbe r]
. Record all errors.
AudibleAlarm disabled
command via CLI as
dr ive in f o
for a list of all
or
Advertisement
Table of Contents
