XYZ Printing DA VINCI MINI SERIES User Manual page 5

2.Installing the Filament spool ring
1 2
Use a phillips screw- Separate the spool ring
driver to loosen the from both sides of the
securing screws of the spool.
filament spool ring.
3.Installing the filament
1
Remove the side cover by pressing down
firmly at the center on the left side of the
cover and pushing aside the cover. (pay
attention to where you apply your force to
ensure proper dismantling) Keep the side
cover securely for future use.
Handy tips
• The filament will load better when the tip of the filament is cut at a 45° angle.
• When the printer is not in use, raise the filament spool holder and close the side cover.
(please refer to this step if the axle ring is not installed on the spool)
3
Retrieve the filament
spool and chip.
2
Lower the filament spool
holder on the left side of
the printer until horizontal.
4 5
Install the sensor chip. Feed both parts of the
Note the orientation of spool ring through the
the sensor chip on the center hole of the
spool ring. spool and assemble
them together.
3 4
Place the assembled Take the tip of the
filament spool (with filament and
the spool ring) on insert it into the
the spool holder. feeding hole.
6
Use a phillips screw-
driver to tighten and
secure the spool ring
to complete the
installation.
5
Press the release arm and
push the filament all the
way to the bottom so that
the front end of the
filament is completely
inserted into the extruder
module.
- 5 -