Table of Contents
Advertisement
2. Label the faceplate, so that it will be easier to find the device if you have to
troubleshoot a network problem.
3. In the wiring closet, connect a cable to the Token-Ring connector on the patch
panel or other equipment where the building wiring terminates.
Note: Do not connect these cables to the Ring-In or Ring-Out port on a media
access unit (MAU) unless you use port 19 or 20 on the switch.
4. Connect the other end of the cable to a Token-Ring port on the switch.
5. Label this cable.
6. If the switch is rack-mounted, dress the switch end of the cables through a cable
management bracket, if one is present on your rack.
7. To continue installing the switch, continue with "Applying Power" on page 32.
Figure 7. Connecting using Building Wiring
Checking the Installation
Before you apply power to the switch, inspect the installation thoroughly. Verify
that all cables are installed correctly. Check cable routing, so a cable will not be
damaged or create a safety hazard. Be sure all equipment is mounted properly and
securely.
CrossFire 8730 Switch Installation Guide, DOC-7046 v. 1.2
CrossFire 8730
Fast Ethernet Translation Switch
STACK-LINK
ACT
ACT
ACT
ACT
STATUS
100
100
STATUS
100
100
FAULT
LINK
LINK
FAULT
LINK
LINK
TX
RX
ATTACH
21-22
21
22
FAST ETHERNET
25-26
25
26
MANAGEMENT
PWR
DIAG
ERR
RST
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
31
Installation
Advertisement
Table of Contents
Troubleshooting
