Olicom CrossFire 8730 Installation Manual page 30

20
2b. The cord must be UL listed, CSA labelled, and consist of three conductors
with a maximum of 15 feet in length. Type SVT or SJT cord sets shall be
used for units which stand on a desk or table. Type SJT cord sets shall be
used for units which stand on floor.
2c. The male plug for units operating at 115 VAC shall consist of a parallel
blade, grounding type attachment plug rated 15 A, 125 VAC.
The male plug for units operating at 230 VAC shall consist of a tandem
blade, grounding type attachment plug rated 15 A, 250 VAC.
The male plug for units operating at 230 VAC (outside of the United States
and Canada) shall consist of a grounding type attachment plug rated 15 A,
250 VAC and have the appropriate safety approvals for the country in which
the equipment will be installed.
Caution: Support the CrossFire 8730 Switch while you are installing the unit to
avoid dropping it on the floor or any equipment beneath it in the rack. The CrossFire
8730 unit weighs approximately 9.5 kg (20.9 lbs).
Caution: To separate the switch from the power, pull the power cord completely
out from the socket. The power socket must be easily accessible and located near
the unit.
Warning: All RJ-45 connectors must only be connected to safety extra low voltage
(SELV) circuits like local area networking (LAN).
Warning: This product relies on the building's installation for short-circuit
(overcurrent) protection. Ensure that a fuse or circuit breaker no larger than
120 VAC, 15A U.S. (240 VAC, 10A international) is used on the phase conductors
(all current-carrying conductors).
Warning: A voltage mismatch can cause equipment damage and may pose a fire
hazard. If the voltage indicated on the label is different from the power outlet
voltage, do not connect the chassis to that receptacle .
Caution : If you are using the redundant power supply unit CrossFire 8311 note that
this unit is not hot-swappable. Both the CrossFire 8311 unit and the switch must
be off before connecting or disconnecting the DC power cable.
CrossFire 8730 Switch Installation Guide, DOC-7046 v. 1.2 Preparing for Installation