Applying Power; Figure 8. The Back Panel - Olicom CrossFire 8730 Installation Manual

32

Applying Power

The switch chassis does not have an on/off switch. Power is on when the unit is
plugged into a power source .
There are no user serviceable parts inside a switch. Any internal upgrades or service
should be performed by qualified personnel only .
Warning: Unplug the power cord before you work on a system that does not have
an on/off switch.
Warning: When installing the unit, the ground connection must always be made
first and disconnected last.
Warning: This equipment is intended to be grounded. Ensure that the host is
connected to earth ground during normal use.
Warning: Do not touch the power supply when the power cord is connected. Line
voltages are present within the power supply when the power cord is connected.
Use the following steps to power on your equipment.
1. Ensure that you are using the correct power source.
2. Using a power cable that complies with national regulations, plug the female
end of the cable into the AC power connector on the back panel of the switch
(see Figure 8).
3. Plug the male end of the power cord(s) into a properly grounded electrical
outlet.

Figure 8. The Back Panel

CrossFire 8730 Switch Installation Guide, DOC-7046 v. 1.2
AC connection Redundant Power Supply
~ LINE 50/60Hz
EXTERNAL DC SUPPLY
100-127VAC, 1.5A
200-240VAC, .75A
HIGH VOLTAGES
For selection of power cord
POWER SUPPLY COVER
set please refer to the manual
MAY ONLY BE REMOVED BY
"Guide to Operations"
AUTHORIZED PERSONNEL
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions. (1) This device may not cause
harmful interference, and (2) this device must
LISTED
C
I. T. E. accept any interference received, including
3C04 interference that may cause undesired operation.
Installation