23
and make sure that the workstations and servers in the network have been
configured to use a maximum frame length of equal or less than the switch. If this
is not done you may experience problems after the switch has been installed in the
network.
Cables and Distances between Devices
The Token-Ring ports supports attachment to 100 ohm and 120 ohm twisted-pair
(UTP or STP), and 150 ohm STP, as defined in the EIA/TIA 568A and ISO/IEC
11801:1995.
The Fast Ethernet ports use standard or crossover UTP-5 copper cables.
See Appendix A, "Cable and Pin Information" for specific information on
supported cable types, cable lengths and connector pinouts.
CrossFire 8730 Switch Installation Guide, DOC-7046 v. 1.2
Preparing for Installation