Olicom CrossFire 8730 Installation Manual page 50

40
20 21 22 25 26 29
- Initializing system address table
- System entering stand-alone mode
- Booting TS Ports: 21 22 25 26
- System initialization complete- Enabling port: 1 2 3 4 5 6 7 8 9 10
11 12 13 14 15 16 17 18 19 20 21 22 25 26 29
Press RETURN key to activate console...
Depending upon which tests have run, verify that all diagnostics have passed and
that the ERR LED is off. If the ERR LED is on, read the screen to determine which
test failed. See also Chapter 5, "Troubleshooting", to help find the cause.
At the end of the boot messages, you should be prompted to press
). The following greeting screen of the switch console interface should appear:
ENTER
At the top level screen, press the
Note: If you have forgotten the password, you can delete it by depressing the
unlabeled SysReq button on the front panel of the switch for one second. Then
release it and select Point 4. Clear the system password .
The following sections in this chapter shortly describes the main menu and provide
information about navigating in the switch console interface.
All of the menus and screens in the switch console interface are described in the
CrossFire 8730 Fast Ethernet Translation Switch—Reference Guide.
descriptions cover configuring and monitoring the switch as well as viewing
statistics on the switch.
CrossFire 8730 Switch Installation Guide, DOC-7046 v. 1.2
key (
ENTER RETURN
RETURN
) to enter the main menu.
These
(that is,
Switch Access