Unpacking Instructions; Materials Needed For Installation - Olicom CrossFire 8730 Installation Manual

26

Unpacking Instructions

There are no special safety precautions that need to be taken when unpacking the
switch. Simply follow these steps:
1. Open the large carton.
2. Remove the switch from its protective packaging.
3. Visually inspect the switch to ensure that it was not damaged during shipment.
4. Check the contents of the carton. See section "Unpacking and Inspecting" on
page 21 for a list on package contents.
If any item is missing or damaged, contact your local Olicom representative.

Materials Needed for Installation

To install the switch, you need the following items:
•
If the unit will be installed in a rack, you need:
— A rack inventory chart and a cabling chart from your network
administrator.
— The supplied set of screws, nuts and washers along with the Allen key tool.
— A properly earthed power cord.
•
If the unit will be installed on a surface (such as a tabletop), you will need:
— A cabling chart from your network administrator.
— The four supplied adhesive rubber feet.
— A properly earthed power cord.
CrossFire 8730 Switch Installation Guide, DOC-7046 v. 1.2 Installation