Cannot configure for USB connection.
Windows 95 and NT 4.0 do not support USB; Windows
98 upgraded from Windows 95 may not support USB.
Possible cause
USB cable does not meet
specifications.
Interface is disabled.
Configuration procedure
was not correctly
followed or cancelled.
USB cable is
disconnected or faulty.
A USB hub is being used. The printer cannot be used with a USB hub.
The USB cable is
installed in the Ethernet
port.
NOTE
Remedy
Use USB cable to specification Ver.1.1.
Check that USB interface is set to Enable in
the menu (
USB MENU
Configure again from the beginning.
Reconnect or try another cable.
Connect the printer and computer directly.
Make sure the USB cable is plugged into the
black USB port (
Troubleshooting • 131
→
→
USB
ENABLE
1
) on the printer:
).