Replacing Or Adding A Hard Drive - Dell Vostro 220 Service Manual

8 Disconnect the data cable from the system board (see "System Board
9 Follow the procedure in "After Working on Your Computer" on page 45.
10 When you restart your computer, check the drive configuration

Replacing or Adding a Hard Drive

1 Follow the procedures in "Before Working on Your Computer" on page 35.
2 Remove the computer cover (see "Removing the Computer Cover" on
3 Check the documentation for the drive to verify that it is configured for
4 For the Vostro 220s:
Downloaded from www.Manualslib.com
Components" on page 40) and remove the cable from the computer.
information in the system setup program:
Enter the system setup program (see "System Setup Program" on
a
page 129 for instructions).
In the Drives section of the system setup program, under Drive 0
b
through 3, set the drive setting to the correct configuration.
page 47).
your computer.
Raise and hold the hard-drive release latch.
a
Slide the drive partway out of the bay, rotate the back of the drive
b
upward until the drive is perpendicular to the drive cage, and guide
the screws through the cutaway channels in the drive cage until you
can lift the drive away from the computer.
Repeat step a and step b for the second hard drive, if installed.
c
manuals search engine
69
Drives