Adding Or Replacing A Second Hard Drive - Dell Dimension J2936 Owner's Manual

J2936bk0.book Page 82 Tuesday, September 2, 2003 3:06 PM
Secure the card with the securing screw.
3
Replace the computer cover (see page 99).
4
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then
plug it into the computer.
Connect your computer and devices to electrical outlets, and turn them on.
5

Adding or Replacing a Second Hard Drive

CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions on page 9.
CAUTION: To avoid damage to the drive, do not set it on a hard surface. Instead,
set the drive on a soft surface, such as a foam pad, that will sufficiently cushion
it.
Shut down the computer through the Start menu (see page 27).
1
Ensure that your computer and attached devices are turned off. If your computer and
2
attached devices did not automatically turn off when you shut down your computer,
turn them off now.
NOTICE: To disconnect a network cable, first unplug the cable from your computer and then
unplug it from the network wall jack.
Disconnect any telephone or telecommunication lines from the computer.
3
Disconnect your computer and all attached devices from their electrical outlets, and
4
then press the power button to ground the system board.
82
Adding Parts
securing screw
filler bracket