Dell Vostro 220 Service Manual page 83

4 If you are adding an optical drive in a bay that has not had a device
5 Remove the optical drive from its packaging.
6 Gently slide the optical drive into the bay from the front of the computer.
7 For the Vostro 420 and Vostro 220:
8 Connect the power cable and data cable to the back of the drive.
9 Ensure that the other end of the data cable is connected to the SATA4,
Downloaded from www.Manualslib.com
previously installed in it, remove the break-away metal plate (front-panel
insert) from the empty drive bay (see "Removing a Drive Bay Break-Away
Metal Plate" on page 85).
Align the screw slots in the optical drive with the screw slots on the
a
drive cage.
Replace and tighten the two screws securing the optical drive.
b
NOTICE:
The connectors are "keyed" for correct insertion; that is, a notch or a
missing pin on one connector fits with a tab or a filled-in hole on the other
connector. Align the cable connectors correctly before inserting them to avoid
damage to the connectors.
SATA5, or SATA6 connector on the system board (see "System Board
Components" on page 40.
manuals search engine
83
Drives