Power Problems - Dell Vostro 220 Service Manual

that the network is functioning.
U N T H E
R
page 12.

Power Problems

F T H E P O W E R L I G H T I S B L U E A N D T H E C O M P U T E R I S N O T R E S P O N D I N G
I
"Power Lights" on page 9.
F T H E P O W E R L I G H T I S B L I N K I N G B L U E
I
a key on the keyboard, move the mouse, or press the power button to resume normal
operation.
F T H E P O W E R L I G H T I S O F F
I
power.
• Reseat the power cable in the power connector on the back of the computer and the
electrical outlet.
• Bypass power strips, power extension cables, and other power protection devices to
verify that the computer turns on properly.
• Ensure that any power strips being used are plugged into an electrical outlet and are
turned on.
• Ensure that the electrical outlet is working by testing it with another device, such as a
lamp.
• Ensure that the main power cable and front panel cable are securely connected to the
system board (see "System Board Components" on page 40).
F T H E P O W E R L I G H T I S B L I N K I N G A M B E R
I
receiving electrical power, but a system board failure may exist.
• Ensure that the voltage selection switch is set to match the AC power at your location
(if applicable).
• Ensure that all components and cables are properly installed and securely connected
to the system board (see "System Board Components" on page 40).
F T H E P O W E R L I G H T I S S T E A D Y A M B E R
I
incorrectly installed.
• Ensure that the processor power cable is securely connected to the system board
power connector (POWER2) (see "System Board Components" on page 40).
Downloaded from www.Manualslib.com
A R D W A R E R O U B L E S H O O T E R
H T
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
manuals search engine
— See "Hardware Troubleshooter" on
— The computer is in standby mode. Press
— The computer is either turned off or is not receiving
B E E P C O D E
,
— A device may be malfunctioning or
— See
3 — The computer is
Troubleshooting
27