Remote Control & Programming - Russell Hobbs RHRV200 R-VAC PET Instructions & Warranty

REMOTE CONTROL & PROGRAMMING:
The Remote control is synchronised with your vacuum cleaner prior to purchase.
REMOTE CONTROL: BATTERY INSTALLATION & REPLACEMENT
1. Open the cover on the back of the Remote control.
2. Insert AAA batteries (not included) with correct polarity as marked (+/-).
3. Replace the cover on the back of the Remote control.
IMPORTANT: Remove the batteries if the Remote control will not be used for an extended
period of time.
If your Remote control isn't operating correctly, it may be necessary to re-synchronise
it with the R-Vac Pet using the following steps:
1. Turn the power switch on the side of the R-Vac Pet to OFF.
2. Press and hold the OK button on the remote control, keep the button down until
step 4 is confirmed.
3. Turn the power switch on the side of the vacuum to ON.
4. Release the OK button after the R-Vac Pet has emitted a series of beeps, indicating
it has synchronised.
NOTE: If you fail to hear the beeps while synchronising, repeat the above process.
TIMER
10