Trouble Shooting - Russell Hobbs RHRV200 R-VAC PET Instructions & Warranty

REMOVING, REPLACING AND CLEANING UNDER THE SIDE BRUSH:
1. Using a screw driver, release the screw in the main shaft of the side brush. (see Figure 4)
2. Remove the side brush and clean the cavity with the dust cleaning brush.
3. Place the side brush back into position and refit the screw.
Figure 4
REMOVING, REPLACING AND CLEANING THE FRONT WHEEL:
1. Remove the entire front wheel assembly: using a flat head screw driver, from the front of
the unit, position the screw driver down and under the front wheel assembly. Pop the wheel
assembly out using the screw driver and clean the cavity.
2. Remove the wheel: using a flat head screw driver, position the screw driver down and under
the front wheel. Pop the wheel of the assembly out using the screw driver and clean the
cavity and the axle. Refit the wheel.
TROUBLE SHOOTING: Error codes will appear on the remote control
ERROR ERROR CAUSE
CODE
E001
Ground detection
sensors
E002
Middle brush
E003
Power off
E004
Left & Right wheel
E005
Dust bin contact
FF60
Incorrect key sequence
when programming
If the errors above have been checked and the vacuum is still not functioning correctly,
please contact customer service for advice. Do not disassemble the unit.
HOW TO SOLVE
Clean the sensors underneath of the vacuum,
at the front
Clean both brushes as per section "CLEANING
THE MAIN BRUSH AND FLOOR BRUSH"
Charge vacuum until fully charged, then use again
Check the left and right wheels and clean any dust
or hair build-up.
Check the dust bin and ensure it is securely
in place. Clean the dust bin contacts
Clear code from the remote by pressing 'Set', 'Stop'
and 'Set' again. Ensure remote is out of programming
mode before (ie. nothing is flashing on screen).
18