Battery Installation And Replacement - Russell Hobbs RHRV200 R-VAC PET Instructions & Warranty

QUICK START GUIDE
While the R-Vac Pet is a complex product, we have committed to making the operation as
user friendly as possible. As a result of this, you can have your R-Vac Pet working for you by
following our 3 quick steps.
1. Install R-Vac Pet's rechargeable battery (page 6)
2. Charge your R-Vac Pet (page 8)
3. Press the AUTO button to have your home vacuumed for you (page 9)
Once your R-Vac Pet has vacuumed your home, it is important to give it a little attention.
Please spend approximately 5 minutes after each cycle cleaning your R-Vac Pet. By giving
your R-Vac Pet this attention it will save you hours of vacuuming each week as well as
providing you with a more thorough clean. Please refer to the cleaning instructions on page 15.

BATTERY INSTALLATION AND REPLACEMENT

Installing and replacing the rechargeable battery:
1. Place the robotic vacuum cleaner upside down on a flat stable surface.
2. Using the screwdriver provided, remove the screws on the battery cover. (Refer to Figure 1)
3. Lift the battery cover away from the unit.
4. Attach the connector on the battery with the connector in the battery compartment by
pushing them together until they click into place and are firmly secured. (Refer to Figure 2)
IMPORTANT: The connectors will only fit together one way. Do not try to force them together if
they are not correctly aligned.
5. Hold the battery by the material tabs and lower it into the battery compartment while
guiding the cables and connectors into the cavity provided in the bottom of the battery
compartment.
6. Replace the battery cover and screws.
7. Return the vacuum to its upright position.
8. Place the vacuum on charge, there are 2 charging options:
a. Using the adapter only - plugged directly into the DC socket (located next to the ON/OFF
switch), or
b. With the adapter connected to the charging station and plugged into a wall
power outlet, place the vacuum onto the charging station.
NOTE: The vacuum will charge when the Power switch is in the ON or OFF
position.
NOTE: The power indicator will flash when the vacuum is charging.
c. Allow the vacuum to charge for at least 12-14 hours before first use, or if it
has not been used for an extended period of time.
d. After charging for at least 12-14 hours, your vacuum is ready for use.
e. When the vacuum is fully charged, the power indicator light will stop flashing, and will
remain illuminated. For the first charge, if this occurs prior to 12-14 hours of charging,
ignore the light and leave the vacuum on charge.
6