Suction Control; Switching Off - Russell Hobbs 13760 Instructions, Troubleshooting Manual And Guarantee

13 You'll have your own preferences, but here are few tips for the first time user.
big brush
normally used with the extendable tube, for floors and carpets.
Press the rear of the brush pedal to extend the bristles for hard floors,
or floor coverings without pile.
Press the front of the brush pedal to retract the bristles for use on rugs,
carpets, and anything with pile.
crevice tool as the name implies, down the sides of upholstery, in awkward spaces,
nooks, and crannies nothing else can reach.
small brush use it to remove pet hair, lint, and dust from blinds, curtains, and
upholstery; to brush/clean awkward corners.
14 The small brush is part of the crevice tool. To use, turn it a bit more than 90° from the
crevice tool, to store, turn it back, parallel to the crevice tool. It can be stored in a
niche at the rear of the cleaner.
tubes
15 Fit the extendable tube for floors, carpets, or for those hard to reach places:
a) grip the end of the inner tube in one hand, the outer tube in the other
b) turn your right hand quarter of a turn anti-clockwise to unlock the tubes
c) move the inner tube in or out to the length you require
d) turn your right hand quarter of a turn clockwise to lock the tubes
16 Push the wide end of the extendable tube on to the main nozzle.
17 Choose a tool, and push it onto the narrow end of the tube.

suction control

18 There are two ways to control the suction:
a) The suction control on top of the cleaner – slide it towards max to increase the
cleaning power, towards min to decrease the power.
b) The suction control on the nozzle – move it towards from main nozzle for
maximum suction, away from the nozzle to reduce suction.
plug in
caution
If you've accidentally pressed the on/off switch, the cleaner could come on
when you plug it in. This could give you a bit of a start, so be careful.
19 Plug the cable into a socket near the area to be cleaned (switch the socket on, if it's
switchable).
switching on
20 Press and release the on/off switch 3, to turn the cleaner on.
cleaning
21 Move the tool over the surface, cleaning a small area at a time.
22 When you move to a new area, overlap the previous area, to make sure none of the
surface is missed.
switching off
23 If you've finished, if you want to change tools, or if you just want to stop, press and
release the on/off switch 3, to turn the cleaner off.
finished cleaning?
24 Press and release the on/off switch 3, to turn the cleaner off.
5