Table of Contents
Advertisement
ServSwitch Multiuser
2. Press F2. The Settings window appears. See Figure 5-2.
Using the Tab key, navigate downwards in the Settings window. At the bottom
of the window, press the Tab key to go to the top of the window. To change set-
tings, type in the selected area or press the spacebar.
5.3 Changing the Network Parameters
DHCP enable—When a DHCP server is active on the same network that the
ServSwitch Multiuser is connected to, DHCP provides automatic IP assignment.
This is displayed in the OSD.
DHCP disabled (recommended)—You can assign a fixed IP address to the
ServSwitch Multiuser. Consult your network administrator about using the DHCP.
When DHCP is disabled, enter the IP address, subnet mask, and gateway as
given by your network administrator.
Once the IP address is correct, press Esc twice to save changes and restart the
unit. As explained below, you can now log in to the web interface to complete
the configuraton.
Page 18
Figure 5-2. Settings window.
724-746-5500 | blackbox.com
Advertisement
Table of Contents
