Table of Contents
Advertisement
Installing the head
WARNING! If using lifting equipment to raise or lower the head, use slings
The Vector 90 head may be installed on a standard 'Vinten' tripod or pedestal using the four
mounting bolts and washers provided or by using a `Quickfix' adaptor.
Adaptors are available which enable the heads to be installed on tripods or pedestals fitted with
other mountings. These are listed in the Parts List under
WARNING! Before installing the head, hold a fixing bolt in position and
After mounting the head on a tripod, use the level bubble
be illuminated by pressing the illumination button (10). The light will go out after approximately 15
seconds.
Pan bars
Fit the pan bars on the mountings
clamps. Adjust the length of the telescopic pan bar. Optional fixed and short fixed pan bars are
available (see
Main assemblies
Fitting a camera
WARNING! Do not rely on the tilt brake when changing the payload.
To fit a camera, proceed as follows:
If not already fitted, install the wedge adaptor
(11)
(see Servicing).
Attach the wedge to the camera/lens.
Operation
or straps. DO NOT use shackles.
Ensure that slings or straps are securely attached to the head. A
suitable lifting point is at the rear of the platform, accessed by
moving the sliding plate
DO NOT attach lifting slings or straps to the carrying handle.
check that the threaded end does not project more than 12 mm
(15/32 in.) above the mounting face
(15)
and adjust the position of each one before tightening the
in the Parts List).
Always engage the centre lock.
Ensure that the weight and C of G height of the total payload is
within the range for which the head is designed
If installing on a pedestal, lock the pedestal in the fully
depressed position before installing the camera.
(13)
to the fully forward position.
Optional
accessories.
(9)
to set it level. The level bubble may
(12)
in the middle position on the sliding plate
Back
13
Advertisement
Table of Contents
