Fig 4.3 Top Clamp Adjustment - Vinten Protouch Pro-6HDV System Maintenance Manual And Parts List

Contents
14.3 While sliding the leg in and out, gradually tighten the threaded insert
to grip.
14.4 If not aligned, back off the threaded insert
14.5 Back off the threaded insert
14.6 Install screw
Bottom clamp
15 Using a flat-bladed screwdriver, carefully remove the hole plug
16 Remove the retaining screw
17 Rotate the clamp knob
vertical. In this position the clamp is NOT fully rotated counterclockwise in the 'off' position.
18 Using a 2.5 mm hexagonal wrench, loosen the adjusting grubscrew
under its own weight.
19 While sliding the leg in and out, gradually tighten the adjusting grubscrew
to grip.
20 Rotate the clamp knob
move under its own weight.
21 Secure the clamp knob
(21.6).
(21.2)
(21.1) to secure the threaded insert (21.2).
(21.2)
(21.1)

Fig 4.3 Top clamp adjustment

(21.5) and washer (21.4), but do not remove the clamp knob (21).
(21) to 'position 2' shown in
(21) fully counterclockwise to the 'off' position and ensure that the leg is free to
(21) with the washer
(21.2) until a slot aligns with the hole for screw (21.1).
a further three slots
(21.6) (Fig
(Fig 4.4), with the edge of the clamp knob
(21.4) and retaining screw (21.5). Refit the hole plug
First Previous Next
Page Page Page
(21.2) until the clamp begins
(21)
4.4).
(21.3) until the leg is free to move
(21.3) until the clamp begins
Previous
View
(21)
29