Removing Compressor and Compressor Heads
Compressor
1. Unplug concentrator and carefully remove compressor from concentrator. Refer to
Removing/Replacing Compressor Assembly on page 31.
Compressor Head
NOTE: For this procedure, refer to FIGURE 7.3.
1. Clean loose dirt from the outside of the
compressor.
2. Use the T‐25 Torx wrench and loosen
the eight head screws.
NOTE: Note placement of the head before
removing.
3. Carefully remove the compressor head
and head seal o‐ring (not shown).
Valve Plates
NOTE: For this procedure, refer to
FIGURE 7.3.
NOTE: Note the position of the valve plates
before removing.
1. Lift off the valve plate on one side.
2. Repeat STEP 1 on opposite side.
NOTE: To avoid confusion, ONLY service one
end of the compressor at a time.
Part No 1164934
SECTION 7—COMPRESSOR
Head Screws
Head
Seal
O-Ring
(Not
Shown)
Valve
Plate
FIGURE 7.3 Removing Compressor and
Compressor Heads - Rebuilding the
Compressor - Compressor - Compressor
Head - Valve Plates
35
Head
Screws
Compressor
Head
Valve
Plate
Compressor
™
Perfecto
V
2