Appendix 5: Installation And Use Of The Blower And Thermodisc - Enerzone Destination 2.3 Installation And Operation Manual

Appendix 5: Installation and Use of the Blower and Thermodisc

Your Enerzone stove comes with a blower assembly and a thermodisc kit. The blower assembly is
secured to the back of the stove using 4 screws (screws #10 x ½'' type ''a'' pan quadrex black.
The blower increases the flow of air past heat exchange surfaces and help circulate warm air in the
room. When used regularly, the blower can provide a small increase in efficiency, up to 2 percent.
However, the use of a blower should not be used as a way to gain more output from a stove that is
undersized for the space it is intended to heat.
You can also install the quick connect thermodisc kit, included with your stove, to enable the
blower to start or stop automatically when the stove is hot or too cold.
Characteristics of the thermodisc:
•
Starts the blower when the stove's temperature reaches 43 °C (110 °F)
•
Cuts the electrical contact when the temperature falls to 32 °C (90 °F).
Installation:
Insert the eyelet of the ground wire (A) in one of the provided screws.
1.
2. Fix the back of the thermodisc case (B) to the back of the stove with two screws. The eyelet of
the ground wire must be wedged between a screw and the interior of the back of the
thermodisc case.
3. Fix the lid (C) to the thermodisc case using the last provided screw.
4. Connect the blower to the power outlet of the quick connect thermodisc and connect the power
cord of the thermodisc to a power outlet in your residence.
Destination 2.3 Installation and Operation Manual
53