WG1605-G-E3,WG1605-L-E3,WG1605-GL-E3, WSM
(3) Cylinder Head, Valves and Oil Pan
Cylinder Head Cover
1. Remove the cylinder head cover cap nut (1).
2. Remove the cylinder head cover (2).
3. Remove the intake manifold (3).
(When reassembling)
• Check to see if the cylinder head cover gasket is not damaged.
Cylinder head cover cap
Tightening torque
nut
(1) Cylinder Head Cover Cap Nut
(2) Cylinder Head Cover
Rocker Arm and Push Rod
1. Remove the rocker arm bracket nuts (1).
2. Remove the rocker arm assembly (2).
3. Remove the push rods (3).
(When reassembling)
• When putting the push rods (3) onto the tappets (4), check to
see if their ends are properly engaged with the dimples.
IMPORTANT
• After installing the rocker arm, be sure to adjust the valve
clearance.
Tightening torque
Rocket arm bracket nut
(1) Rocker Arm Bracket Nut
(2) Rocker Arm Assembly
1-S28
ENGINE
6.9 to 8.8 N·m
0.71 to 0.89 kgf·m
5.1 to 6.4 lbf·ft
(3) Intake Manifold
9Y1210661ENS0081US0
21.6 to 26.5 N·m
2.21 to 2.70 kgf·m
16.0 to 19.5 lbf·ft
(3) Push Rod
(4) Tappet
9Y1210661ENS0082US0
KiSC issued 05, 2014 A