General Assembly Instructions - Vacmaster VWM1218R Operator's Manual

GENERAL ASSEMBLY INSTRUCTIONS

WARNING:
DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Undo the latches. (fig. 2)
3. Lift the power head off of the container. (fig. 3)
4. Remove the contents from inside the container, make sure you have all contents as listed on page 5.
(fig. 4)
5. Replace the power head to the container and insert the noise diffuser into the blowing port. (fig. 5)
MOUNTING RACK AND STORAGE ASSEMBLY
IMPORTANT! （only fit for timberwork house）
•
Mount the rack so that when the vac is fitted the distance between VAC sucking port and the floor is not
over 1.5 m.
•
Do not screw the rack to drywall only. Secure the screws to a stud.
•
Do not hang from or sit on the mounting rack
•
Do not exceed 18 KG of maximum weight limit.
6. Insert the hose holding rod into the two holes located on the top of the mounting rack. Make sure the
bend of the rod is directed away from the wall. (fig. 6)
GB
DO NOT PLUG IN POWER CORD TO POWER OUTLET, MAKE SURE PLUG IS
6