Configuring Multilink Trunks - Nortel 10BASE-T Using Manual

Using the BayStack 410-24T 10BASE-T Switch

Configuring MultiLink Trunks

To create or modify a MultiLink trunk, follow the flowchart in
Choose MultiLink Trunk Configuration (or press t) from the MultiLink Trunk
Configuration Menu screen to open the MultiLink Trunk Configuration screen.
Figure C-7.
C-8
MultiLink Trunk
Configuration screen
Are all
No
trunk members
configured?
Yes
No
Is trunk
STP Enabled?
Yes
No
Is trunk
Enabled?
Yes
Done
Configuring MultiLink Trunks
Configure trunk members
(see "MultiLink Trunking
Configuration Rules").
Configure STP field.
Enable Trunk Status field
(see "MultiLink Trunking
Configuration Rules").
Key
Off-page reference
On-page reference
BS41052A
Figure C-7.
309985-C Rev 00