Table of Contents
Advertisement
Specify a default gateway address/default route.
3.
When configuring IP on most layer 2 switches, you need to specify the IP
address of the device and the IP address of the default gateway.
Use the following Boot Monitor CLI command to specify the default route:
net mgmt route net 0.0.0.0 <ipaddr>
Use the following Run-Time CLI command to specify the default route:
config bootconfig net mgmt route net 0.0.0.0 <ipaddr>
In each of these commands,
gateway.
To save the configuration, enter:
4.
save config
Your Passport 8100 switch now has an IP address and can be used as a layer 2
switch.
204515-C
specifies the IP address of the default
ipaddr
Basic Switch Configuration
3-9
Advertisement
Table of Contents
