Using the Passport 8100 Modules
Table B-2
Table B-2.
Module LEDs on the Passport 8132TX and 8148TX Modules
Label
Color/State
Fault
Yellow/Steady
Yellow/Blinking
Off
Master
Green/Steady
Yellow/Steady
Off
Online
Green/Steady
Green/Blinking
Yellow/Steady
Off
Table B-3.
Port LEDs on the Passport 8132TX and 8148TX Modules
LED
Color/State
10/100
Green/Steady
(Speed)
Off
Link/Activity
Off
Green/Steady
Green/Blinking
Passport 8108GBIC Module
The Passport 8108GBIC module has three LEDs to indicate module and system
operating conditions
the presence of link and data activity
of the LEDs.
B-4
describes the module LEDs, and
Meaning
A diagnostics failure or hardware failure has been detected.
A chassis failure has been detected.
The system is functioning normally.
This module is properly generating the system clock for the switch.
This module has detected system clock generation failure on its own
circuitry.
This module is not providing the system clock for the switch. You can pull
this module out of the chassis without resetting the switch.
The module is functioning normally and is in switching mode.
The module is running diagnostic tests.
The module is not in switching mode.
Software incompatibility exists, or the module cannot communicate with the
master module over the backplane.
The module is not receiving power or is administratively disabled.
Meaning
The port is set to operate at 100 Mb/s.
The port is set to operate at 10 Mb/s.
No link exists, or the port is disabled.
The link is good.
The link is good, and the port is transmitting or receiving traffic.
(Table
B-4). In addition, each port has two LEDs to indicate
Table B-3
describes the port LEDs.
(Table
B-5).
Figure B-3
shows the locations
204515-C