Table of Contents
Advertisement
Using the Passport 8100 Modules
To correct this mode mismatch problem:
Use the CLI to disable autonegotiation for the suspect port.
1.
Refer to Reference for the Passport 8000 Command Line Interface Switching
Operations for the appropriate CLI commands.
Use the CLI to set the speed and duplex mode of the port to match the
2.
speed/duplex mode of the connected station.
You may have to try several settings before you find the correct speed/duplex
mode of the connected station.
If the problem persists, follow these additional steps:
Using the CLI, disable the autonegotiation feature at the connected
1.
station.
Manually set the speed/duplex mode of the connected station to the same
2.
speed/duplex mode you have manually set for the Passport 8100 module
port.
Note: Nortel Networks recommends that you manually set the Passport 8100
module port to the desired speed/duplex mode when connecting to any of the
following Nortel Networks products:
• Nortel Networks 28000 product family
• Nortel Networks 58000 product family
• BayStack
Port Interface
Verify that the devices are connected using the appropriate crossover or
straight-through cable. (For information about appropriate cables, refer to
Appendix A, "Technical
4-6
302T switch (100 Mb/s port)
™
Specifications.")
204515-C
Advertisement
Table of Contents
