Table of Contents
Advertisement
5V Power Supply
3•4
+5V Power Supply Connection
The MSC8101 requires +5V DC @ 4A max, power supply for operation. Connect the +5V power
supply to connector P26 as shown below:
P26 is a 3 terminal block power connector with power plug. The plug is designed to accept 14 to
22 AWG wires. It is recommended to use 14 to 18 AWG wires. To provide solid ground, two GND
terminals are supplied. It is recommended to connect both GND wires to the common of the power
supply, while "Hot" line is connected with a single wire.
3•5
JTAG/OnCE Connector - P6
The MSC8101ADS JTAG/OnCE connector, P6, is a 14 pin, two rows, header connector with key.
The connection between the MSC8101ADS and the Command Converter is by a 14 line flat cable,
MOTOROLA
Freescale Semiconductor, Inc.
Installation Instructions
FIGURE 3-3 Stand Alone Configuration
Audio
Stereo
FIGURE 3-4 P26: +5V Power Connector
1
+5V
2
GND
3
GND
NOTE
Since hardware applications may be connected
to the MSC8101ADS via the expansion connec-
tors P1 and P2, the additional power consump-
tion should be taken into consideration when a
power supply is connected to the MSC8101ADS.
MSC8101ADS RevB User's Manual
For More Information On This Product,
Go to: www.freescale.com
Host
Computer
T1/E1
four ch.
21
Advertisement
Table of Contents
