Table of Contents
Advertisement
SCND_CFG_BYTE_READ,
THIRD_CFG_BYTE_READ,
FOURTH_CFG_BYTE_READ,
F_PD[4..1],
T1_EN_OUT_NODE,
T234_EN_OUT_NODE,
CODECEN_OUT_NODE,
FETHIEN_OUT_NODE,
CONF_ADD[0..1],-- CONFIGURATION ADDRESS
CFG_BYTE0[0..7],
CFG_BYTE1[0..7],
CFG_BYTE2[0..7],
CFG_BYTE3[0..7],
END_OF_FLASH_READ,-- "1" if DSP has ended Flash reading
END_OF_ATM_READ,-- "1" if DSP has ended ATM reading
DATA_HOLD_END,
-- "1" if Data_Hold counter has reached its limit
EE0_HOLD_END,
EE45_HOLD_END,
END_OF_IMPULSE,
END_OF_WD_TIMER,
EEPROM_ENABLE,
RESETS,
CLEAR_TO_WD_CTRL,
WritetoBcsr,
PRST_Ensure_END
: NODE;
%
****************************************
********* BCSRs Bits Description *******
****************************************
%
%********************************************************************************
*
BCSR0
********************************************************************************%
HOSTCSP,
-- BCSR0 Bit 0. Host CS Polarity
HOSTRQAC,
-- BCSR0 Bit 1. Host Request or Acknowledge Select
HOSTTRI,
-- BCSR0 Bit 2. Host Request or Acknowledge Enable
T1_1EN~,
-- BCSR0 BIT 3. T1 port 1 enable
T1_234EN~,
FrmRst~,
SIGNAL_LAMP_0~,-- BCSR0 Bit 6. LED0 illuminate command.
SIGNAL_LAMP_1~,-- BCSR0 Bit 7. LED1 illuminate command.
%*******************************************************************************
*
BCSR1
********************************************************************************%
SBOOT_EN~,
CODEC_EN~,
ATM_EN~,
ATM_RST~,
FETHIEN~,
FETH_RST~,
RS232EN_1~,
RS232EN_2~,
%********************************************************************************
C-106
Freescale Semiconductor, Inc.
-- "1" if EE0_Hold counter has reached its limit
-- "1" if EE45_Hold counter has reached its limit
-- End of PORESET pulse when divider will achive max value
-- End of WD count
-- Access to EEPROM is available (write/read)
-- Misc Node
-- End of Altera PRST count
-- BCSR0 Bit 4. T1 ports 1,2,3 are enable
-- BCSR0 Bit 5. Framer Reset
-- BCSR1 Bit 0. Serial BOOT Enable
-- BCSR1 Bit 1. CODEC with Ethernet Enable
-- BCSR1 Bit 2. ATM Port enable
-- BCSR1 Bit 3. ATM Port Reset
-- BCSR1 Bit 4. Fast Ethernet Port Initial enable
-- BCSR1 Bit 5. Fast Ethernet Port Reset
-- BCSR1 Bit 6. RS232 port 1 enable
-- BCSR1 Bit 7. RS232 port 2 enable
MSC8101ADS RevB User's Manual
For More Information On This Product,
Go to: www.freescale.com
*
*
MOTOROLA
Advertisement
Table of Contents
