Nortel NN44200-300 Hardware Installation page 30

30 Chapter 3 Preparing for installation
To replace the front bezel after installation is complete
Step
When the CallPilot server installation is complete and the server is in its
final location, replace the front bezel.
1
Copyright © 2007, Nortel Networks
.
IF
components have become loose
you are satisfied that the 1002rp
server has arrived at your site
undamaged
Action
Align the front bezel with the ball studs located at each faceplate
corner.
See the diagram below:
Nortel CallPilot
1002rp Server Hardware Installation
NN44200-300 01.01 Standard
5.0 23 February 2007
THEN
secure them.
Refer to the procedures in the
Installation and Configuration
Task List (NN44200-306).
replace the server cover and
proceed with the hardware
installation.
See "Installation checklist" (page
23).
Note: Do not reinstall the front
bezel until the server is in its
final location and the CallPilot
installation is complete.
—End—
Nortel Networks Confidential