Nortel BSG12aw Installation Manual page 36

36 Installation options
Installing the BSG8ew/12ew/aw/tw on a desktop or shelf
Use this procedure to install a BSG8ew/12ew/aw/tw on a desktop or shelf.
Prerequisites
• Obtain the four supplied rubber feet for the BSG8ew/12ew/aw/tw.
Procedure steps
Step
1
2
3
4
NN47928-302 NN47928-302
Action
If installing the BSG8ew, insert the power supply retention clip.
The BSG12ew/aw/tw uses a different power connector, which does not require
a retention clip.
Attach the four self-adhesive rubber feet to the bottom of the BSG8ew/12ew/aw/
tw by peeling off the paper backing and placing the feet on the unit as indicated
in the following figure.
Position the BSG8ew/12ew/aw/tw on a desktop or shelf. Make sure you leave
enough space around the unit for ventilation and access to the cables.
Install the power supply next to the BSG8ew/12ew/aw/tw.
The power supply must be within 1.5 m (5 feet) of the BSG8ew/12ew/aw/tw
sand within 1.5 m (5 feet) of the AC power outlet.
Attach feet here
End