MOTO GUZZI 1200 SPORT 4V Service Station Manual page 179

1200 SPORT 4V
Specification
Target engine revs
Stepper base
CL Stepper
Stepper regulator
Virtual throttle angle from Stepper
Device status screen page
DEVICE STATUS
This screen page shows the status (usually ON/
OFF) of the vehicle devices or the operation con-
dition of some vehicle systems (for example, lamb-
da probe functioning status).
Specification
Engine status
Throttle position
IGNITION
RUN / STOP switch
Clutch
Gear engaged
Fall sensor
Lambda
Synchronisation
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
D
EVICE STATUS
Stand
Desc./Quantity
1150 rpm (approximate values)
Parameter valid at idle, setting depends especially on the en-
gine temperature: the control unit will try to keep the engine
running at this revs, acting on the ignition advance and the
Stepper motor
70 - 100 (approximate values)
Steps corresponding to the Stepper motor reference position
70 - 150 (approximate values)
Steps set by the control unit for the Stepper motor. At idle, steps
so that the engine keeps the target engine revs set by the con-
trol unit
Difference between current steps of motor at idle and those at
the reference position
With engine not at idle speed, this value indicates the throttle
degrees corresponding to the Stepper motor air flow
Desc./Quantity
ON/run/power-latch/stopped
operation conditions
Released / pressed
indicates if the throttle potentiometer is open or closed
Retracted / expanded
indicates the position of the side stand (only with gear engaged)
Enabled / disabled
indicates if the control unit consents engine start-up
Run / stop
indicates the position of the safety switch
No / Yes
indicates the clutch sensor status
No / Yes
indicates the gear sensor status
Normal / Tip over
indicates the vehicle fall sensor status
Open loop / Closed loop
Indicates if the control unit is using (CLOSED) the lambda
probe signal to keep the stoichiometric combustion. At idle
CLOSED only if: Air T over 20°C (68°F) and engine T over 30°
C (86°F) and engine on for at least 2-3 minutes
Synchronised / Not synchronised
Indicates if the control unit detects the revolution sensor signal
correctly
Power supply
0°
P SUPP - 179