MOTO GUZZI 1200 SPORT 4V Service Station Manual page 176

Power supply
•
Turn on the scanner.
•
Screw the joints connecting the vacuometer pipes on the inlet pipe holes.
•
Connect the vacuometer pipes to the relative joints.
•
Set the key to ON.
•
Make sure there are no errors in the control unit; otherwise, solve them and repeat the
procedure.
•
Make sure the left throttle is fully in.
DO NOT TOUCH THE THROTTLE ABUTMENT SCREW OR
THE THROTTLE BODY MUST BE REPLACED. CHECK
THAT THE THROTTLE RETURN CABLE IS NOT TAUT.
•
The Axone should display the adjustable parameters screen page.
•
Autodetect the throttle position.
•
Turn the key to "OFF" and leave it for
at least 30 seconds.
•
Turn the key back to "ON" and restore
the Axone session.
•
Check that the "Throttle" value reading
is 4.7 +/- 0.2°. If the value is incorrect,
replace the control unit and repeat the
procedure from the start.
•
Completely close the two by-pass
screws on the throttle bodies.
•
Start the engine.
•
Take the engine to the prescribe tem-
perature: 60 °C (140 °F).
•
Make the engine rev at 2000/3000 rpm
and with the vacuometer check that the
difference between the two pressures
is 1 cm Hg (1.33 kPa) maximum.
If this condition is detected:
•
take the engine back to idle and check
the depression values so that they are
aligned between the two cylinders.
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
P SUPP - 176
1200 SPORT 4V