Assembly B: Footrest; Adjusting The Foot Rests/Tube Foot Rest/Foot Plates; Replacing The Footrest Adapter - Otto Bock discovery tmax Service Manual

Service Work
2) If a lashing point is installed, also loosen 1 x Allen head screw and 1 x pin (see Fig. 11, item 2).
3) Loosen 3 x Allen head screws on the back plate/push handle connection (see Fig. 11, item 3, 1 x Allen head
screw not illustrated).
4) Remove and replace the back plate.
INFORMATION:If required, the back plate depth position can be adjusted after loosening the 2nd back
plate (see Fig. 12, item 2).
5) Reinstall the back plate. Screw the rear cross tube into place at the same time (see Fig. 12, item 1).
6) Tighten all Allen head screws to 10 Nm.

3.6 Assembly B: Footrest

3.6.1 Adjusting the Foot Rests/Tube Foot Rest/Foot Plates

All instructions concerning the adjustment of the foot rests are included in the Instructions for Use (qualified per­
sonnel) – order number 647G585.

3.6.2 Replacing the Footrest Adapter

INFORMATION
► The process for installing the footrest adapter for the standard footrest and the elevating footrest is generally
the same.
► If footrests for short lower leg lengths are to be installed, the footrest adapters have to be switched and
rotated 180°. The locking devices also have to be repositioned (see Page 14).
1) Loosen the Allen head screws on the seat frame (see Fig. 13, item 1).
2) Remove the lashing point if applicable.
3) Remove and replace the footrest adapter.
4) Bring the footrest adapter to the desired position (see Fig. 13, item 2).
INFORMATION: Note the minimum insertion depth. The footrest adapter needs to be secured with 2
screws.
5) Tighten all Allen head screws to a torque of 10 Nm.
12 | Ottobock
11
13
12
discovery tmax