GAUI Hurricane 425 Assembly Instruction Manual page 14

Wiring & Installing
IMPORTANT 請注意
Notic: With the servo at its neutral position,
make sure the four control sticks are all in
middle position,and the setting of CCPM
SWASH AFR are all in 50%.
組裝伺服機時，需將搖控器設定為CCPM SWASH
AFR都設定為50%並將遙控器開啟(全部保持
中立位置)
IMPORTANT 請注意
Drill the holes on servo horn as figure above
if using the parts of #204511 and #204514.
Use the standard 180 degrees servo horn for
the CNC parts #204612 and #204614. (No
drilling necessary)
標準版的前舵片及後搖臂舵片有夾角設計
為精確控制請自行鑽孔。(金屬舵片則無
夾角設計)
1.Install the servo.(#204703 CF servo plates
are suitable for small servo 35.5x15mm.)
(Fig.1)
先確認伺服機尺寸，標準的可直接鎖上，較
小的(35.5X15mm)可利用轉接板來鎖。(圖一)
2.Install the servos and the linkages,the
length of the linkage should be set as figure.
(Fig.2 & 3)
鎖上伺服機，調整推桿所需長度(每組需相同)
再安裝。(圖二~圖三)
3.Install the rudder servo and the tail pushrod
as shown in figure.(Fig.3)
鎖上伺服機，校正如前，尾拉桿需穿過
尾管夾及拉桿座。(圖三)
4.The tail pushrod should be parallel to the
tail boom,use C/A to adhere rudder control
guide onto tail boom.(Fig.4)
尾拉桿組裝完成後需調整它呈一直線，
無誤後上膠固定於尾管。(圖四)
5.Use the double side tape to Install the gyro,
receiver and the ESC as shown in Fig.5.
(Make sure not to install the ESC on the
receiver batery mount or in the canopy, the
overheated ESC will cut off the motor power
temporarily during flight.)
利用雙面膠將陀螺儀及接收機及ESC固定於機
身如圖五。(勿將ESC安裝在此接收機電池架
或置於艙罩內,散熱不良的ESC可能會在飛行
中進入保護模式而暫時切斷馬達電源。)
6.Use the releasable cable tie to secure the
batteries.(Fig.6)
利用可卸式束帶固定電池。(圖六)
(Fig.4)
(圖四)
電裝組立
(Fig.2)
(圖二)
(Fig.3)
(圖三)
警示:
勿將ESC安裝在此接收機電池架
或置於艙罩內,散熱不良的ESC
可能會在飛行中進入保護模式
而暫時切斷馬達電源。
CAUTION:
The ESC must not be
installed here or or in the
canopy, the overheated
ESC will cut off the motor
power temporarily during
flight.
(Fig.6)
(圖六)
P.12
38mm
55mm
Receiver
(Fig.1)
(圖一)
38mm
ESC
GYRO
(Fig.5)
(圖五)