Functional Description - Bosch 0 602 207 Original Instructions Manual

OBJ_BUCH-640-001.book Page 31 Thursday, September 17, 2009 12:24 PM
current-conducting dust. Not using a residual
current protection device can lead to electri-
cal shock, risk of fire, or serious injuries.
The residual current protection device
should be installed in the power supply net-
work only by a qualified electrician. Only in
this manner can proper functioning be en-
sured.
The output voltage and frequency of the fre-
quency converter must correspond with the
data on the type plate of the high-frequency
tool.
Operate the power tool exclusively with a
fitting plug. The CEE plug must be dimen-
sioned for the nominal current that the pow-
er tool requires (see "Technical Data").
Plug mounting and connection to the power
supply is to be carried out by a qualified
electrician trained in handling high-frequen-
cy tool systems.
Use only original cables! Before each use,
check the power tool, cable and plug for
possible damage. Cables and plugs may not
be repaired, but must be exchanged in order
to avoid danger.

Functional Description

Read all safety warnings and all
instructions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or
serious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
Intended Use
Type 0 602 207 ..., 0 602 208 ..., 0 602 209 ...,
0 602 210 ..., 0 602 211 ..., 0 602 212 ...,
0 602 213 ..., 0 602 240 ..., 0 602 242 ...,
0 602 243 ..., 0 602 245 ...
The machine is intended for grinding and de-
burring metal using corundum grinding acces-
sories.
Bosch Power Tools
Type 0 602 238 ...
The machine is intended for light grinding appli-
cations on workpieces with hard to reach loca-
tions, e.g., in inaccessible cavities of turbines.
Applies for all types
Use only the blade guards, collet chucks and
clamping nuts provided or specifically released
for this power tool.
Product Features
The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Grinding accessory
2 Collet of the collet chuck
3 Collet chuck
4 Grinder spindle
5 Spindle housing
6 On/Off switch
7 Protection guard for grinding
8 Locking lever
9 Threaded sleeve
10 Two-pin spanner for clamping nut
11 Clamping nut
12 Mounting flange
13 Locking screw for protection guard
14 Open-end spanner for mounting flange
15 Grinder spindle extension
16 Open-end spanner (21 mm) on the spanner
surfaces of the threaded sleeve
17 Open-end spanner (21 mm) on the spindle
housing or extension
18 Open-end spanner on the collet chuck
19 Open-end spanner on the grinder spindle
20 Cable strain relief (CEE plug)
21 Plug insert (CEE plug)
22 Screw (CEE plug)
23 Screws in plug insert 21 (CEE plug)
24 CEE plug
25 Plastic sleeve (CEE plug)
The accessories illustrated or described are not in-
cluded as standard delivery.
3 609 929 B78 | (17.9.09)
English | 31