Yamaha XP500A Owner's Manual page 27

Trip → V-BELT Trip → Odo
1
1. Fuel reserve tripmeter
To reset a tripmeter, select it by push-
ing the "SELECT" button until "F Trip",
"Trip-A" or "Trip-B" is displayed. While
"F Trip", "Trip-A" or "Trip-B" is dis-
played, push the "RESET" button for at
least one second. If you do not reset
the fuel reserve tripmeter manually, it
will reset itself automatically and the
display will return to the prior mode af-
ter refueling and traveling 5 km (3 mi).
TIP
The display cannot be changed back to
"F Trip" after pushing the "RESET" but-
ton.
INSTRUMENT AND CONTROL FUNCTIONS
Oil change indicator "OIL"
1. Oil change indicator "OIL"
This indicator flashes at the initial 1000
km (600 mi), then at 5000 km (3000 mi)
and every 5000 km (3000 mi) thereafter
to indicate that the engine oil should be
changed.
After changing the engine oil, reset the
oil change indicator. To reset the oil
change indicator, select it by pushing
the "SELECT" button until "OIL Trip" is
displayed, and then push the "RESET"
button at least 1 second. When pushing
the "RESET" button, "OIL Trip" starts
flashing. While "OIL Trip" is flashing,
push the "RESET" button for at least 3
seconds.
If the engine oil is changed before the
4-8
oil change indicator "OIL" flashes (i.e.
before the periodic oil change interval
1
has been reached), the indicator "OIL"
must be reset after the oil change for
the next periodic oil change to be indi-
cated at the correct time.
The electrical circuit of the indicator can
be checked according to the following
procedure.
1. Set the engine stop switch to "
and turn the key to "ON".
2. Check that the oil change indicator
comes on for a few seconds and
then goes off.
3. If the oil change indicator does not
come on, have a Yamaha dealer
check the electrical circuit.
2
3
"
4
5
6
7
8
9