Authorisation - Gigaset E490 Manual

Customer Service & Assistance
Handset does not ring.
¥
The ringer is deactivated.
Activate the ringer (
You cannot hear a ringer/dialling tone from the
fixed line network.
The phone cord supplied has not been used or
has been replaced by a new cord with the wrong
¥
pin connections.
Please always use the phone cord supplied or
ensure that the pin connections are correct
when purchasing from a retailer (
Error tone sounds after system PIN prompt
¥
You have entered the wrong system PIN.
Reset the system PIN to 0000 (
Forgotten the system PIN.
¥
Reset the system PIN to 0000 (
Call charges are not displayed.
1. Your network provider does not support this
feature.
¥
2. There are no metering pulses.
Ask your network provider to transmit the
metering pulses.
The other party cannot hear you.
u
You have pressed the
¥
is "muted".
Activate the microphone again (
The number of the caller is not displayed
despite CLIP.
¥
Calling Line Identification is not enabled.
The caller should ask the network provider to
enable Calling Line Identification (CLI).
You hear an error tone when keying an input
(a descending tone sequence).
¥ Action has failed/invalid input.
Repeat the operation.
Watch the display and refer to the user guide if
necessary.
You cannot listen to messages on the network
mailbox.
Your PABX is set for dial pulsing. ¥
Set your PABX to tone dialling.
58
¢
page 52).
¢
page 7).
¢
page 54).
¢
page 54).
(INT) key. The handset
¢
page 22).
E495 Gigaset only:
No time is specified for a message in the calls
list.
Date and time have not been set. ¥
Set the date/time (
The answering machine announces "PIN is
incorrect" during remote operation.
¥
1. You have entered the wrong system PIN.
Enter the system PIN again.
¥
2. The system PIN is still set to 0000.
Change the system PIN (
The answering machine is not recording any
messages/has switched over to announce only.
¥
Its memory is full.
¥ Delete old messages.
Play back new messages and delete.

Authorisation

This device is intended for connection to
analogue networks outside the EEA (with
the exception of Switzerland) depending on
national type approval.
Country-specific requirements have been
taken into consideration.
We, Gigaset Communications GmbH,
declare that this device meets the essential
requirements and other relevant regulations
laid down in Directive 1999/5/CE.
A copy of the 1999/5/EC Declaration of Con-
formity is available at this Internet address:
www.gigaset.com/docs
¢
page 12).
¢
page 53).