Power Supply - Sanyo MCD-Z110F Instruction Manual

PRECAUTIONS
The apparatus shall not be exposed to drip-
ping or splashing.
Do not use where there are extremes of tem-
perature (below 5 'C or exceeding 350C).
Because of the CD player's extremely low
noise and wide dynamic range, there might
be a tendency to set the volume on the am-
plifier unnecessarily high. Doing so may pro-
duce an excessively large output from the
amplifier which could damage your
speakers.
Sudden changes in the ambient temperature
may cause condensation to form on the op-
tical lens inside the unit. If this happens,
take out the disc, leave the unit for about 1
hour, and then proceed to operate.
Do not install this equipment in a confined
space, such as a book case or built in
cabinet.
The rating label is located on the bottom of
the unit.
CONTROLS (Fig. 1)
1. Function switch (FUNCTION)
2. Volume control (VOLUME)
3. Skip/Search buttons (SKIP/SEARCH)
4. Remote sensor (IR)
5. Telescopic aerial
6. CD Track number display (CD TRACK NO.)
7. CD Compartment lid
8. CD Compartment opening button
(CD OPEN)
9. Indicators (CD PLAY, REPEAT, MEMORY)
10. Play/Pause button (PLAY/PAUSE)
11. Stop/Clear button (STOP/CLEAR)
12. Radio band switch (BAND)
13. Tuning control (TUNING)
14. Memory button (MEMORY)
15. Cassette holder
16. Pause button (PAUSE)
17. Stop/Eject button (STOP/EJECT)
18. Fast forward button (FFWD)
19. Rewind button (REW)
20. Play button (PLAY)
21. Record button (REC)
22. Repeat button (REPEAT)
23. Headphones socket (PHONES)
24. Bass expander button (BASSXPANDER)
25. AC input socket (AC INPUT)
26. Battery compartment lid
27. Beat cancel switch (BEAT CANCEL)
POWER SUPPLY
AC POWER
Connect one end of the mains lead to the AC INPUT
socket and the other end to an AC outlet.
Note:
The installed batteries are automatically
disconnected when the mains lead is con-
nected to the unit.
The FUNCTION switch is mounted on the
secondary side. The unit is not discon-
nected from mains, even switched off.
BATTERY POWER
Installing batteries
Install eight "R20/D" batteries (not supplied) as
shown in Fig. 2.
Cautions on batteries
To prevent battery electrolyte leakage, which may
result in injury and damage to the unit or other
objects, observe the following precautions:
1.
2.
3.
4.
5.
All batteries must be installed with the
proper polarity (see diagram on the rear of
the unit).
Do not mix new with old or used batteries.
Only use batteries of the same type and
brand.
Remove the batteries when they are not to
be used for a long period time.
When the batteries have become
discharged, they must be disposed of in a
safe manner which complies with all appli-
cable laws.
4